11
D
Initial set-up of MINIPRESS
!
D5
D6
D3
D2
3/8"
(10 mm)
L
L
1.
2.
3.
D7
3. Installation of base ruler (D2)
• Loosen both clamping levers (D3)
on the fencing System.
• Lift locating pin (D5), and slide base
ruler (D2), until the locating pin
snaps into the center hole of the
locating plate (D6).
• Tighten clamping levers (D3).
4. Mounting the swivel stops (D7)
• Loosen the locking bolt until the T-
nut projects by 3/8“ (10 mm).
• Tilt the swivel stop against the ruler
and raise the stop.
• Tighten the locking bolt.
Note:
Follow the same procedure to
place a stop between two
existing stops.
%$0,1,35(66)$,G1US $0
To Next Page
Loading...
