Service Manual for RESmart
®
BPAP V1.1
2/18
2.2 Inner Construction
See appendix A
2.3 Spare Part
See appendix B
3. Software
3.1 Instruction for Upgrading Device Software
Note: Once the RESmart
®
BPAP device is powered on, the LED display screen will show the
software version of the device as the following picture. Please remember the software version in the
red frame.
1. Power off the RESmart
®
BPAP device, and then connect PC and the device via data cable.
2. Run the software “BMC RESmart
®
Tools for Upgrade” from PC and display as below:
Medical Product Note (bottom)
AC Inlet
Communication Connector
Filter Cap & Filter
Indicator
Li
ht
Water Chamber
Fill Line
Outlet Port
Heater
Plate
To Next Page
Loading...
Need help?
General
