What does 4 RED flashes mean on my BMPRO SwayControl?
If your BMPRO Controller is flashing 4 RED times, it means there is a short in the right side brake. You should correct the short in right side brake wiring.
Why is my BMPRO SwayControl Controller flashing RED fast?
A fast RED flashing light on the BMPRO Controller indicates low voltage, specifically between 3 and 6V. To resolve this, check the quality of the power and ground connections.
What do 2 RED flashes on a BMPRO SwayControl mean?
Two RED flashes on the BMPRO Controller indicate a sensor malfunction, meaning there is no sway control of the trailer. Service centre repair is required.
What does 1 RED flash mean on my BMPRO SwayControl?
One RED flash on the BMPRO Controller indicates a system malfunction. Service centre repair is required.
General| Connectivity | Wired |
|---|---|
| Input Voltage | 12V DC |
| Brake Output Current | Up to 20A |
| Operating Temperature | -20°C to 60°C |
| Water Resistance | IP65 |
| Max Current | 20A |
| Brake Output Voltage | 12V DC |
| Protection | Over-temperature |
Lists integrated and aftermarket brake controllers compatible with the SwayControl system.
Details the suggested location for mounting the SwayControl on the trailer chassis.
Describes how to securely fasten the SwayControl unit using mounting flanges and screws.
Details the five wires of the harness and their required electrical connections.
To Next Page
