Activating
After switching off the drive-ready state, briefly
push the indicator lever forward.
Setting the duration
1. "CAR"
2. "Settings"
3. "Exterior lighting"
4. "Pathway lighting"
5. Select the desired setting.
6. "OK"
Daytime running lights
General information
▷ ,
▷ Depending on the national-market version:
The daytime running lights light up when drive-
ready state is switched on.
Depending on the national-market version: after
switching off the drive-ready state, the parking
lights will illuminate in position .
Activating/deactivating
In some countries, daytime running lights are
mandatory, so it may not be possible to deacti‐
vate the daytime running lights in front.
1.
"CAR"
2. "Settings"
3. "Exterior lighting"
4. Depending on country specifications:
"Daytime driving lights" or "Daytime driving
lights, rear"
Adaptive light functions
Concept
Adaptive light functions enable dynamic illumina‐
tion of the roadway.
General information
The adaptive light functions may consist of one
system or multiple systems, depending on the
equipment version:
▷ Adaptive Light Control.
▷ Cornering light.
Activating
Position of switch:
The adaptive light functions are active when the
drive-ready state is switched on.
Adaptive Light Control
General information
Depending on the steering angle and other pa‐
rameters, the laser high beams follow the course
of the road.
Cornering light
In tight curves, for instance on mountainous
roads or when turning, an additional, cornering
light is switched on that lights up the inside of
the curve when the vehicle is moving below a
certain speed.
The cornering light is automatically switched on
depending on the steering angle or, where appli‐
cable, the use of turn signals.
When driving in reverse, the cornering lights may
be automatically switched on regardless of the
steering angle.
Seite 174
CONTROLS
Lights
174
Online Edition for Part no. 01405A2C7F8 - II/21
To Next Page