The warning stops when the other vehicle has
left the critical area or the turn signal has been
deactivated.
Vehicles with side collision
mitigation
When there is no response to the vibration of the
steering wheel at speeds of up to
130 mph/210 km/h and the lane marking is
crossed, the system intervenes with a brief active
steering intervention. The steering intervention
helps return the vehicle into the lane. The steer‐
ing intervention can be noticed on the steering
wheel and can be manually overridden at any
time.
Flashing of the light
A flashing of the light during vehicle unlocking
serves as system self-test.
System limits
Safety information
Warning
The system is designed to operate in certain
conditions and circumstances. Due to condi‐
tions or other factors, the system may not re‐
spond. There may be a risk of accident or risk
of damage to property. Actively intervene as
warranted. Refer to the information in this Own‐
er’s Manual regarding the scope of the sys‐
tem’s operation and limitations.
Upper speed limit
If the vehicle speed exceeds approx.
155 mph/250 km/h, the system is deactivated
temporarily.
If the vehicle speed falls below approx.
155 mph/250 km/h, the system once again re‐
sponds according to the setting.
System limits of the sensors
Additional information:
▷ Radar sensors, refer to page 36.
▷ On vehicles with side collision warning: cam‐
eras, refer to page 35.
Functional limitations
The system may be limited in the following situa‐
tions:
▷ When a vehicle is approaching at a speed
much faster than your own.
▷ In tight curves or on narrow lanes.
▷ If the bumper is dirty, iced up, or covered,
for instance by stickers.
For vehicles with side collision mitigation, the
steering intervention can be limited, for instance
in the following situation:
▷ In the event of missing, worn, poorly visible,
merging, diverging, or multiple lane markings
such as in construction areas.
▷ When lane markings are covered in snow, ice,
dirt or water.
▷ When lane markings are not white.
▷ When lane markings are covered by objects.
▷ When driving very close to the vehicle in front
of you.
▷ If the camera is impaired.
▷ Up to 10 seconds after the start of the engine
via the Start/Stop button.
A Check Control message is displayed when the
system is not fully functional.
Displaying warnings
Depending on the selected warning settings,
e.g., warning time, more or fewer warnings can
be displayed. However, there may also be an ex‐
cess of premature warnings of critical situations.
Seite 201
Safety
CONTROLS
201
Online Edition for Part no. 01405A2C7F8 - II/21
To Next Page