NOTICE
The compressor can overheat during extended
operation. There is a risk of damage to prop‐
erty, among other potential damage. Do not run
the compressor for more than 10 minutes.
Filling
1. Shake the sealant container.
2. Pull filling hose completely out of the cover of
the sealant container. Do not kink the hose.
3. Slide the sealant container into the holder on
the compressor housing, ensuring that it en‐
gages audibly.
4. Screw the filling hose of the sealant container
onto the tire valve of the nonworking wheel.
5. With the compressor switched off, insert the
connector into the power socket in the vehi‐
cle interior.
6. With standby state or drive-ready state
switched on, switch on the compressor.
Let the compressor run for max. 10 minutes to fill
the tire with sealant and achieve a tire inflation
pressure of approx. 2.0 bar.
While the tire is being filled with sealant, the tire
inflation pressure may sporadically reach approx.
5 bar. Do not switch off the compressor at this
point.
Seite 334
MOBILITY
Wheels and tires
334
Online Edition for Part no. 01405A2C7F8 - II/21
To Next Page