2
40
Maintenance and care
Low-beam headlight
e Attention:
Switch off the ignition before
changing a bulb.
Route the cable in such a way
as to ensure that it cannot be
trapped or pinched.
L Note:
Do not touch new bulbs with
your fingers.
Use a clean, dry cloth to hold
the bulbs when inserting them.
• Prop the motorcycle on its
side stand
– Make sure the ground is
level and firm.
• Remove rubber cap 2
• Squeeze clip 1 and push it
down at the same time to dis-
engage it
Changing bulbs
1
2
20K14bkg3.book Seite 40 Mittwoch, 19. Mai 2004 11:57 11
To Next Page
Loading...
