78
Controls Controls overview
11 Adjusting settings
> Confirmation signals when locking and
unlocking the vehicle 25
> Response during unlocking
procedure 23
> Automatic locking 27
> Pathway lighting 97
> Daytime running lights 97
> Triple turn signal activation 63
> Seat memory 45
Exiting displays
The outside temperature reading and the time
reappear when you press button 2 or if you
make no entries within approx. 15 seconds. If
required, complete the current setting first.
Formats and units of measure
In the instrument cluster
Setting the units of measure
You can set formats and units of measure.
1. Switch on the ignition, refer to page 53.
2. Briefly press button 1 in the turn signal/high
beam lever up or down repeatedly until the
symbol appears in the display, accompa-
nied by the word "SET".
3. Press button 2.
4. Use button 1 to select desired format or
desired unit of measure, e.g. for fuel con-
sumption.
> Fuel consumption: mpg, km/l,
l/100km
> Distance covered: mls, km
> Time: 12h, 24h format
> Date: day.month dd.mm,
month/day mm/dd
> Temperature: 7, 6
5. Press button 2.
6. Use button 1 to make the setting.
7. Press button 2.
The setting is stored for the remote control
currently in use.
Resetting to factory settings
You can reset the settings for formats and units
of measure to the factory settings.
1. Briefly press button 1 in the turn signal/high
beam lever up or down repeatedly until the
symbol appears in the display, accompa-
nied by the word "SET".
2. Press button 2.
Online Edition for Part no. 01402918638 - © 02/13 BMW AG
To Next Page
Loading...
Need help?
General
