Engine Covers
Each cylinder head has a plastic cover for the ignition coil cabling and top of the cylinder
head. The covers “push fit” into rubber grommets on the cylinder head covers.
A sound absorption cover for the top of the
engine also covers the two Valvetronic motors.
This cover is fixed to the intake manifold hous-
ing using four bolts.
The cylinder head covers are made from plastic. The retaining sleeves for the ignition coils
have molded-on gaskets. The sleeves must be replaced if any hardening or damage is vis-
ible on the gaskets. The sleeves are inserted into the cylinder head through the cylinder
head cover (nos. 1through 4).
NNootteess::
21
N62 Engine
42-02-21
Engine Covers
Cylinder Head Cover
1. Cylinder Head Top Cover
2. Sound Absorption Engine Cover
1-4. Opening for Spark Plugs
5. Pressure Control Valve
6. Opening for Valvetronic Motor
7. Opening for Valvetronic Sensor Connector
8. Camshaft Sensors (Intake and Exhaust)
43-02-12
To Next Page
Loading...
