21
SONY CDU-33A/31A and other SONY
interface CD-ROMS.
1. Exit Windows and insert the SE1440 CD-
ROM diskette into the A: or B: drive.
2. At the A: or B: prompt type CD SONY to
go into the SONY directory.
3. At the A:\SONY or B:\SONY prompt, type
173A, then press ENTER. This will
uncompress the necessary files.
4. At the A:\SONY or B:\SONY prompt, type
SETUP, then press ENTER to start the
installation.
5. Say “Yes” to install the SLCD.SYS driver.
6. Accept the default directories.
7. Allow the installation to update both your
CONFIG.SYS and AUTOEXEC.BAT files.
8. Say “No” for installation on a Server and
changing the Cache size.
9. Re-start your system.
Installing Your New SE1440
To Next Page