7.3 Gateway configuration
Press '3' (GW) from the IP configuration menu and enter
the new gateway address using the KELIO
PRIO digital
keypad; press 'E' to confirm (press 'C' to correct if you
make a mistake):
Note: If the gateway is not used, the address must be "0.0.0.0".
7.4 Network test
The terminal has a menu that lets you test the network.
1. To access it, press '2' (TST) from the administrator menu
welcome screen:
Note: Press '1' (BOOT) to reboot the terminal (terminal
reset).
2. Press '2' (PING) and enter the destination address
of the machine to ping (the default address
127.0.0.1 corresponds to the terminal's localhost
address).
3. Press 'E' to confirm to launch the ping on the
remote machine:
The terminal displays the following message during the
ping test:
The terminal displays the following result if the remote
machine responds to the ping:
If the remote machine does not respond to the ping, the
terminal displays the following result:
8. ADJUSTING THE DISPLAY CONTRAST
The LCD’s screen contrast can be adjusted.
The contrast adjustment is activated for a maximum of 3 seconds when the terminal boots up:
- Press the F1 function key to reduce the contrast,
- Press the F2 function key to increase the contrast.
The keys return to their main function once these 3 seconds have expired.
To Next Page
Loading...
Need help?
General
