10
S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE: Tighten all hardware at the end of this step.
A. Attach both Base Caps (34) to Base Frame (A) at the positions shown.
B. Insert Foot Cap (32) into Base Frame (A).
C. Insert two Foot Caps (32) into Left Stabilizer Frame (D).
D. Insert two Foot Caps (32) into Right Stabilizer Frame (C).
E. Insert two End Caps (28) into Selector Insert Frame (N).
F. Make sure Pop-Pin (17) is preinstalled into Selector Tube (O).
G. Set Selector Insert Frame (N) into Selector Tube (O) then secure Selector Tube (O) to Base
Frame (A) using:
One 3 (M12x90 hex head bolt)
Two 21 (M12x25 washer)
One 18 (M12 nylon lock nut)
H. Connect Right Stabilizer Frame (C) and Left Stabilizer Frame (D) to Base Frame (A) using:
Two 2 (M12x80 hex head bolt)
Four 22 (M12x34 washer)
Two 18 (M12 nylon lock nut)
To Next Page
Loading...
