Operating instructions for S 40-3...S 150-3 series screw compressors Page 57
Maintenance 6.2 The BOGE maintenance concept
General information
concerning the lubri-
cants used
We recommend using only oil according to the following specification:
– Viscosity range of 55 cSt at 104°F.
– Minimum viscosity at 212°F of 8 cSt.
– Maximum viscosity at 32°F of 1,000 cSt.
– Excellent oxidation stability: Meets requirements of Pneurop oxidation test.
– Antifoam – additives.
– Additives to prevent residue formation.
– Compatibility with all used sealing materials like Neoprene, FPM, PTFE,
FKM (Viton) and acrylic and epoxy resin paints.
– Flash point > 446°F.
– Additives for excellent demulsifying properties.
– Additives for corrosion protection of metallic surfaces.
– Excellent oxidation stability: Rotating bomb oxidation Test (ASTM D 2272)
higher than 2,400 minutes.
– Or you use BOGE compressor oil Syprem S. The stated maintenance inter-
vals refer to the use of Syprem S only.
– Syprem S can be purchased from BOGE retailers.
– Never mix different oil types and brands.
The additives may be incompatible. It may lead to foam formation, prema-
ture ageing or loss of lubricating ability.
WARNING: Risk of injury!
Oil presents a potential danger to health and environment due to their addi-
tives.
– Avoid contact with skin and eyes.
Wear protective gloves made of resistant synthetic material.
Wash yourself thoroughly after contact with oils.
– Do not inhale the fumes or mist.
– Protect your environment.
Ensure that no oil is spilt.
– Do not eat or drink when working with oils.
– Fire, naked flames and smoking is strictly prohibited when handling oil.
Read and observe the information in the relevant safety data sheets!
To Next Page
Loading...
Need help?
General
