1-866-771-2663 | Page 9
To Light
To Extinguish
Before performing a leak test, be sure that no sparks can occur and you are in a spacious outdoor
area. Connect the propane gas tank to the regulator and turn the valve on the unit to the “off”
position. Brush a soap and water mixture on all connections. Turn the gas supply on; if bubbles
occur on any connection there may be a leak. If you smell gas or a leak is discovered turn the
gas valve off, disconnect propane gas tank and do not use the appliance until the leak is
repaired.
Do not use the heating unit without inspecting the gas hose. If there are signs of wear or abrasion
you must replace the hose (if applicable). Pumice stones/lava rocks/LavaGlass™ could pop up and
strike somebody’s face during the process of lighting this unit; stand away from the unit for the rst
20 minutes after igniting. Flame height should be a yellow/blue color between 2 - 10 inches in
height.
Wait 5 minutes after extinguishing ame prior to placing a lid (if applicable) or protective cover on
heating item.
1. Be sure to remove the lid before lighting the repit.
2. To light the repit, push and turn the control knob (G) on the side of the body (B)
counterclockwise to ignite the piezo ignition. It may take several attempts to light the ignition.
3. To adjust the ame, turn the control knob (G) either clockwise or counterclockwise depending on
whether you want to lower or raise the ame.
1. Push and turn the control knob (G) clockwise to turn off repit.
2. After repit is completely cool, lock lid in place by turning clockwise.
OPERATION
Fir
e pr
oduct and pr
opane gas cylinder minimum
distance must be over 60 inches (as per right side
photo)
W
ARNING
60"
To Next Page
Loading...
