BONFIGLIOLI ACTIVE Cube ACU 401-19 User Manual

User Error VPLC
Code
Meaning
F30 3n
User triggered Error of Internal PLC. Please check the application man-
ual VPLC.
Optional Components
F0A 10
Data transmission from control unit KP 500 to the frequency inverter
not possible. At least one file must be stored in the control unit.
F0B 13
The communication module was fitted to slot B without disconnection
of the mains voltage, switch mains voltage off.
Internal monitoring
F0C 40
After 6 warm starts in less than 3 minutes this fault is triggered, due to
the expectation that a faulty programming of the PLC or the function
table is at hand. Additionally the PLC / Function table is stopped (P.
1399 = 0 only in RAM).
In error occurrence the signal 162 - “Error Signal” is set. The signal can be linked
with inverter functions.
Output signals in error occurrence
Errors are indicated by digital signals.
162 -
Error Signal
1)
Monitoring function signals an error which is displayed in
parameter Current Error 259.
3 -
2)
1)
For linking with inverter functions
2)
For digital output
In addition to fault messages mentioned, there are further fault messages. However
these messages are only used for internal purposes and are not listed here. If you
receive fault mes
sages which are not listed here, please contact the BONFIGLIOLI
customer service.
Please store the parameter file on your PC before contacting BONFIGLIOLI.
268 Operating Instructions ACU 06/13

BONFIGLIOLI ACTIVE Cube ACU 401-19 Specifications

General

Brand	BONFIGLIOLI
Model	ACTIVE Cube ACU 401-19
Category	Inverter
Language	English