Page 3 3BE390758NU – 12/11
BONNET GRANDE CUISINE
Registered Office:
Rue des Frères Lumière - Z.I Mitry Compans
F-77292 MITRY MORY Cedex
♦ IMPORTANT: Please be aware that when cooking dishes prepared with alcohol (coq au vin, pears in
wine, etc.…). Vapour saturated with alcohol may when heated cause an explosion in the oven and due to
the sealed door, create a momentary overpressure which may cause an irreversible deformation of the
panels. This risk is further increased when the user adds alcohol to the products near the end of the
cooking cycle and closes the door to complete cooking.
♦ To ensure long lasting, safe and proper functioning, carry out a full check and maintenance of the
appliance twice a year using qualified personnel from our company (Dismantling of burners, inspection
and cleaning of venturis, cleaning of nozzles, adjustment of air rings, cleaning of vents, checking possible
leaks, checking control elements, regulating and safety accessories…).
♦ The oven must be meticulously and DAILY maintained (see the “Maintenance” chapter). In
particular, the fans, heating elements and walls must be kept clean, without accumulation of
grease and mineral deposits (lime or other).
♦ Preheating (20 level ovens): Whatever the mode, these ovens are designed to be preheated with
the trolley in place.
♦
The manufacturer certifies that the packaging conforms to the provision 94/62/CE of 20.12.94 relating to
packaging and packaging materials and requires the fitter (and the user) to observe the rules relating to
packaging removal (recycling or upgrading of packaging materials).
♦ « According to article 6 of the decree of 20 July 2005 a marking giving the identity of the manufacturer
and the release on the market of the equipment after the 13 August 2005 is indicated on the appliance. »
« The Manufacturer has filled in the National Register. »
As per the legal provisions in force (article 21 & 22 of the decree 2005-829), the customer is responsible
for the obligations relating to the elimination of waste, namely:
- he is to deal with selective treatment, reconditioning and destruction of residues arising from
electric and electronic equipment selectively collected in the installations meeting the technical
requirements or in any other installation authorised for the purpose, in any other member State
of the European Union or in another State in so far as the transfer of these residues out of
France is made according to the provisions of the Regulation of 1st February 1993 indicated
above.
- he must make sure that all fluids of electric and electronic equipment are drained according to
the requirements of the provisions.
- he must make sure that the information relating to the removal and treatment of these residues
is forwarded to any further acquirer.
♦
The warranty will not cover problems caused by failure to comply with these recommendations.
To Next Page
Loading...
