Bonnet Equator 6 Series User Manual

EQUATOR
6
COMBI OVENS
SI
BUILDER’S SPECIFICATIONS
Part C: Maintenance manual
- WARRANTY -
In order to guarantee this equipment, we recommend that you comply with the
MANUFACTURER’S INSTRUCTIONS in this manual.
However if you can not undertake the required maintenance operations, our installation and
service network is available to provide you with a personalized contract.
- WARNING -
• The product delivered to you complies with current standards. If any modifications are made
the manufacturer cannot accept any responsibility whatsoever. The manufacturer can not be
held responsible in the event of an incorrect use of the appliance.
• Keep your manuals.
3BE390691NM

Bonnet Equator 6 Series Specifications

General

Brand	Bonnet
Model	Equator 6 Series
Category	Oven
Language	English

Summary

Functioning and Marking of the Maxi Relay Card

Parameter Setting of the UC Relay Card

Generalities

General information before setting parameters.

Parameter Setting of the Configuration Key

Procedure to set the configuration key for the UC relay card.

Parameter Setting of the Facia

Adjusting parameters on the facia after card change.

Outlet from the Parameter Cycles

Procedure to exit parameter setting cycles.

Changing the Equipment from One Gas to Another

List of Authorised Gases/Pressure According to Categories and Countries

Table of permitted gases and pressures by country.

Changeover from One Gas to Another

Steps for adapting the appliance to a different gas type.

Gas Flow Rates and Powers

Technical data on gas flow rates and power outputs.

Chart of Nozzles

Guide for selecting and identifying gas nozzles by type.

Maintenance

Servicing the Condenser

Instructions for checking and cleaning the condenser and related parts.

Verification of Temperature Sensors

Door Adjustment and Closing

6 & 10 Level Ovens

Specific steps for adjusting doors on 6 and 10 level ovens.

20 Level Ovens

Specific steps for adjusting doors on 20 level ovens.

Renewal of the Driving Shaft Gasket

Maintenance Programme

Inlet into the Programme

Procedure to access the maintenance programme settings.

Counter Reading

How to read and interpret maintenance counters.

Assistance for Maintenance

Steps to verify outlet operation within the maintenance program.

Outlet from Maintenance Cycles

Procedure to exit maintenance cycle testing.