Page 5 3BE390691NM – 10/10
BONNET GRANDE CUISINE
Registered Office:
Rue des Frères Lumière - Z.I Mitry Compans
77292 MITRY MORY Cedex
2.3 PARAMETER SETTING OF THE FACIA (in case the whole card is changed)
Follow the procedure above.
Button 1
The display opposite button 2 should indicate "P03".
Frequency of after sale service
Button 2
The display opposite button 3 should indicate the time programmed between each general
maintenance (The display indicates "xx xx" (x = a figure from 0 to 9)).
Correct according to the frequency of after sale service chosen by turning button 3 (from 100 to 9990
hours).
Temperature unit
Button 2
The display opposite button 3 should indicate the unit (the display indicates temperature in "°C or ° F").
Correct according to the unit chosen by turning button 3 (Celsius degree, °F Fahrenheit degree).
Display of set / ambient temperature
Button 2
The display opposite button 3 should indicate the type of temperature displayed by default (the display
shows "0 or 1").
Correct the figure by turning button 3 to obtain the desired value (0 = set temperature, 1 = ambient
temperature).
To Next Page
Loading...
Need help?
General
