Page 20 3BE390691NM – 10/10
BONNET GRANDE CUISINE
Registered Office:
Rue des Frères Lumière - Z.I Mitry Compans
77292 MITRY MORY Cedex
8. RENEWAL OF THE DRIVING SHAFT GASKET
GENERALITIES
The wear of gaskets arising from an unbalanced turbine due to settling lime scale. The main
consequence of this wear results in steam leaks in the way of the driving shaft, in a modification of cooking
results (coloration, drying).
PROCEDURE FOR CHANGING THE GASKET
- Open the ventilation duct.
- Unscrew the holding screw of the water deflector and remove the deflector.
- Install the hub puller (3 points with flat tips) and extract the turbine
- Remove the gasket
Screw +
deflector
Driving shaft
gasket
Hub puller
To Next Page
Loading...
Need help?
General
