Bosch 2600 Series - Event and VCR Status Retrieval

LTC 2600 Series | Instruction Manual | Multiplexer Read (MR) Commands
Bosch Security Systems | July 12, 2004
EN
|
33
MR-OPERATION-DUPLEX
This command returns the operating modes for duplex
multiplexer models.
Returned parameter values are:
<mode-D1> 1 Monitor A - live digital
2Monitor A - playback
3Record ON - System4
models only
<mode-D2> 0 Record OFF
1Record ON
MR-PASSWORD
This command returns the multiplexer password.
Returned parameter values for <password> are
<digit><digit><digit><digit> where <digit> equals
any number between 0 and 9.
MR-SEQ-DWELL <monitor> <mon-mode>
This command returns the sequence dwell time for the
specified monitor in the specified display mode.
Parameter values are:
<monitor> 1 Monitor A
2Monitor B
<mon-mode> 1 Full screen mode
2 Quad mode
<dwell-time> 0 Sequence disabled
(returned value) 1-60 Dwell time in seconds
MR-SEQ-DWELL-TIME <seq-device>
This command returns the sequence dwell time for the
specified monitor in the specified display mode (<seq-
device>).
Parameter values are:
<seq-device> 1 Monitor A - Full screen
2Monitor A - Quad
3Monitor B - Full screen
4Monitor B - Quad
<dwell-time> 0 Sequence disabled
(returned value) 1-60 Dwell time in seconds
MR-SEQ-ENABLE <monitor>
This command returns the setting (enabled/disabled
sequencing) for the specified monitor if its display
mode is Full or Quad.
Parameter values are:
<monitor> 1 Monitor A
2Monitor B
<boolean> 0 Disabled sequencing
(returned value) 1 Enabled sequencing
MR-SEQ-LIST <monitor> <display-mode>
This command returns the camera list being sequenced
in the specified mode on the specified monitor.
Parameter values are:
<monitor> 1 Monitor A
2Monitor B
<display-mode> 0 Full screen
1 Single quad
2 3x3 multi
3 4+3 multi
412+1 multi
5 4x4 multi
6 8+2 multi
<camera list> A list of camera numbers
(returned value) (1-32) given in the order
desired for the
sequence/display