LTC 2600 Series | Instruction Manual | General Commands
Bosch Security Systems | July 12, 2004
EN
|
38
MR-VIDEOLOSS-OUT-ENABLE
This command returns the status (enabled/disabled) of
the videoloss relay output.
Parameter values are:
0 Disabled videoloss relay
output
1 Enabled videoloss relay
output
MR-WINTER-TIME <date>
This command returns the date when the time-of-day
clock will be put back by one hour (from Daylight
Saving Time back to Standard Time). At 2:00 a.m. /
02:00 on the date set, the hour is put back to 1:00 a.m.
/ 01:00.
MR-ZOOM <monitor>
This command returns the zoom setting (cameo# being
displayed and enable/disable status) for the specified
monitor.
Parameter values are:
<monitor> 1 Monitor A
2Monitor B
<cameo#> 1 to 16
(returned value)
<boolean> 0 Disable
(returned value) 1 Enable
6 GENERAL COMMANDS
6.1 Summary of General Commands
Command Function Description
ABBR <command> <text> Defines an abbreviation to be used instead
of the command string in the ASCII
protocol.
AUX-OFF <camera#> <auxiliary#> Deactivates the specified receiver/driver
camera from its specified auxiliary
function/position
AUX-ON <camera#> <auxiliary#> Sends the specified receiver/driver camera
to the specified auxiliary function/position
AUX-TGL <camera#> <auxiliary#> Toggles the specified auxiliary
function/position on the specified
receiver/driver camera
CANCEL-AUX-LATCH <logical cam#> Stops operation of a LATCH-AUX-ON or
LATCH-AUX-OFF command on the
specified receiver/driver camera
DATE Displays the system date
!DATE Sets the system date
DECIMAL Selects decimal entry of numeric values
DEFAULT Resets all system values to the Factory
Default settings
GET-RS-232 Reads the RS-232 communication
parameters
HEX Selects hexadecimal entry of numeric
values
LATCH-AUX-OFF <logical cam#>
<auxiliary#>
"Unlatches" the specified auxiliary
function/position on the specified
receiver/driver camera
LATCH-AUX-ON <logical cam#>
<auxiliary#>
"Latches" the specified auxiliary
function/position on the specified
receiver/driver camera
PREPOS <logical cam#> <pre-position#> Sends the specified camera to the
specified pre-position
PREPOS-SET <camera#> <pre-
position#>
For the specified camera number in its
current position, sets that position as the
specified pre-position number
R/C <logical cam#> <OpCode#> <data> Sets receiver/driver functions according to
the parameters entered
REMOTE-TGL <camera#> <data1>
<data2>
Sets the pan/tilt/zoom functions
RESET-SYSTEM Resets system (simulates a power off/on
cycle)
REVISION Displays the current software revision
number
SET-RS-232 Selects RS232 communication parameters
TEVENT-TBL Displays all time-event settings in an easy-
to-read table
TIME Displays the system time
!TIME Sets the system time
VARSPEED_PTZ <logical cam#> <pan
speed>
Selects the variable speed functions of the
AutoDome <tilt speed> <zoom speed>
<function code> Series of dome cameras
To Next Page
Loading...
