Bosch 2600 Series - Page 42

LTC 2600 Series | Instruction Manual | General Commands
Bosch Security Systems | July 12, 2004
EN
|
42
EXAMPLE: To activate pre-position # 16 on camera #
1, enter the following command: LTC 2600>R/C 1 2 15
NOTE: Since the decimal mode is being assumed, the
numeric value for the data was selected from the
decimal column in the table. Also note that the actual
number of seconds a time-dependent command will be
activated may only approximate the value entered.
RESET-SYSTEM
This command resets the system (simulates a power
off/on cycle).
REVISION
This command returns the current software revision.
EXAMPLE: For Engineering release E13 1.01, the
value returned is: LTC 2600> E13 1 1
For full release 1.02, the value returned is:
LTC 2600> 1 2
SET-RS-232 <baud> <data bits> <parity> <stop bits>
<handshake>
This command sets the RS-232 communication
parameters: baud rate, data bits, parity, stop bits, and
handshake (in that order).
Parameter values are:
<baud> 0 / 1 / 2 (600 / 1200 / 2400)
3 / 4 / 5 (4800 / 9600 / 19200)
<data bits> 7 or 8 (data bits)
<parity> 0 / 1 / 2 (none / even / odd)
<stop bits> 1 or 2 (stop bits)
<handshake> 0 or 1 (OFF / ON)
EXAMPLE: To select a baud rate of 9600, 8 data bits,
no parity, 1 stop bit, and hardware handshaking off:
<4> is used for "baud", <8> is used for "data bits",
<0> is used for "parity", <1> is used for "stop bits",
<0> is used for "handshake". LTC 2600> SET-RS-232
4 8 0 1 0
TIME
This command displays the system time.
!TIME
To set the time in the system, enter the time in the 24
hour format in the form below: LTC !TIME 13 00 00
VA R SPEED_PTZ <logical cam#> <pan speed> <tilt
speed> <zoom speed> <function code>
This command selects the variable speed functions of
the AutoDome Series of dome cameras. Once a
variable speed command is received by the
AutoDome, it will continue to operate until the "All
Off" or another control command is received.
Parameter values are:
<logical cam#> 1 to 999 (maximum
number of cameras)
<pan speed> 0 to F (hex)--where
0 = slowest, F = fastest
<tilt speed> 0 to F (hex)-where
0 = slowest, F = fastest
<zoom speed> 0 to 7-where 0 = slowest,
7 = fastest
<function code> See following table
Function Hex Decimal
all off 000 0
pan right 001 1
pan left 002 2
tilt down 004 4
tilt up 008 8
zoom out 010 16
zoom in 020 32
focus near 040 64
focus far 080 128
iris close 100 256
iris open 200 512