Bosch 3 842 999 898 - Assembly; Installation requirements

14/40 Assembly
Bosch Rexroth AG, MIT: BS 1/…, 3 842 563 815/2021-11
7 Assembly
7.1 Unpacking
 Lift the product out of its packaging.
 Dispose of the packaging material in accordance with the applicable regulations
in your country.
7.2 Installation requirements
 During installation, be sure to maintain the ambient conditions specified in the
technical data (seepage36).
7.2.1 Installation position
 Install the product level and plumb, at right angles, and axially parallel.
Thisensures proper functioning and prevents premature wear.
7.3 Required tools
• Hex wrench (open-ended spanner) SW8, SW10, SW13, SW19, SW24.
• Hex socket wrenches SW3, SW4, SW5.
• Hexagon socket wrench (Torx™) T30, T50
• Phillips screwdriver PH2
• Spirit level
• Combination pliers
• Flat smooth file
7.4 Required accessories
• Section supports for holding up the belt section.
Please note: Support the belt section in the immediate vicinity of the drive and
return unit. Max. distance between two leg sets: 2000 mm.
–for BS1, BS 1/T, BS 1/M, BS 1/S
SZ 1, 3842996336 or
SZ 1/L, 3842996335
Mounting kit, 3 842 523 431
• For fastening the leg sets on the ground, you need the following for each
connection:
–1x foundation bracket, 3842146815
–1x dowel, 3842526560
–2x T-bolts, 3842528718
–2x flange nuts, 3842345081
• Connection kit for transverse conveying, for utilization of the belt section in
lateral transverse conveying (drive head-at-section).
–BS1/..., 3842525110
• Connection kit for longitudinal conveyor (drive head at return unit)
–BS1/..., 3842525110