Bosch 3 842 999 898 - Assembly on leg sets

Assembly 17/40
3 842 563 815/2021-11, MIT: BS 1/…, Bosch Rexroth AG
7.6.2 Assembly on leg sets
Fig. 6: Removal of protective cap
Fig. 7: Assembling the leg sets
1
F
J
D
X
SW 8
(4x)
SW 5
10 Nm
SW 5
10 Nm
2
BS 1
SZ 1
SZ 1
SZ 1
2
SW <= 2000
1. Remove the yellow
protective cap (X) from
the motor shaft, screw
on the motor (J) with
the mounting kit at the
gear flange (D). Hub in
the gear (F) has already
been lubricated at the
factory.
2. Install BS 1 on SZ 1.
Please note:
• Depending on the
ordered length, the belt
sectionBS1 can be
assembled on two to four
SZ 1 leg sets. SZ 1 are
always installed under
the cross connectors.
Installation example
fig.7: Section length
l=4000 mm with
three SZ 1 leg sets.
ForBS1/S:Longitudinal
transport of the
workpiece pallet with
segmented conveyor
sections of up to
5000mm.
3. Align longitudinally and
transversely, adjust
leveling feet spindles
accordingly.
ENGLISH