Bosch 3 842 999 898 - Symbols Used

Assembly 15/40
3 842 563 815/2021-11, MIT: BS 1/…, Bosch Rexroth AG
7.5 Symbols used
Table 7: Symbols used
21
Connection with T-bolt and flange nut.
Make sure the T-bolt is in the correct position when inserting it into the slot
and tightening it. The notch at the head of the screw indicates the orientation
of the T-bolt.
1=T-bolt insertion position in the slot.
2=T-bolt clamping position in the slot.
Tightening torque: 25Nm
M
D
SW13
= 20Nm
Hex wrench
SW = wrench size …mm
M
D
=required tightening torque ...Nm
M
D
= 8Nm
SW5
Hex socket wrench
SW = wrench size …mm
M
D
= required tightening torque ... Nm
PH3
PZ2
Screwdrivers for cross-head screws
PZ … = Pozidriv screw driver, size …
PH … = Phillips screw driver, size …
gleitmo 585 K Anti-Seize
Lubricate/lubricate with specific grease lubricant:
• gleitmo 585 K: gleitmo 585 K, www.fuchs-lubritech.com
• Anti-Seize: Food Grade Anti-Seize/Loctite 8014, www.henkel.com
Loctite 243 Loctite 601
Secure the screws with:
• Loctite 243: Medium strength (detachable), www.loctite.de
• Loctite 601: High-strength screw retention (non-detachable), www.loctite.de
GHD V 68
Oil Oil Oil
Oil/oil with specific mineral oil:
• GHD: Structovis GHD, www.klueber.com
• V 68: Mineral oil with viscosity 68 acc. to DIN
The marked parts are not required for the described assembly. Dispose of the
parts or use them for other purposes.
2
13
Graphical depiction of the installation steps.
The numbers correspond to the sequence of installation steps, in accordance
with the instructions in the accompanying text.
AB
CX
Graphical depiction of the designation of components.
The letters denote the components mentioned in the accompanying text.
Detail view from adifferent direction,
for example, the back or the bottom side of the product.
ENGLISH