%'$!"
Blade does not completely cut
workpiece.
Head assembly does not slide
freely when attempting a slide
cut.
Head assembly slides forward
and back when making a chop
cut.
Bevel setting does not hold
position.
*(
1. Depth stop screw adjusted
for groove cutting.
1. Slide rail lock knob tight-
ened.
2. Slide rail lock knob not tight-
ened.
1. Bevel lock lever assembly
needs to be tightened.
$'')+)$#
- See Depth Stop Adjustment
in the Adjustment section.
- Loosen slide rail lock knob.
- Push head assembly com-
pletely against stop. Tighten
slide rail lock knob.
- Tighten bevel lock lever as
shown on page 15.
)A>D1;4B7>>C8=6
)A>D1;4B7>>C8=6D8344=4A0;
224BB>A84B
"8C4A8=34AL868C0;=6;4
58=34A><?>D=3DC
0;2D;0C>A%A>CA02C>A!4E4;
Gives you the information needed to position
cuts so that they fit together precisely even if the
room is out of square.
"('4?;024<4=C+4AC820;&D82:;0<?
"(A>F=">;38=6(D??>AC(C>?
Accurately positions and supports crown molding
when angled against the fence.
"(GCA0!>=60B4'>3 8C
Consists of replacement steel rods that extend
the total width of base to 50-1/2”
"(!4=6C7(C>? 8C
"('4?;024<4=C 4A5=B4ACB
"('4?;024<4=CDBC06
))A02'02L%>AC01;4(C0=3F8C7,744;B
)A0E8CH'8B4,744;43"8C4A(0F(C0=3
!("8C4A(0F!0B4A,0B74AD834
-40-
To Next Page
Loading...
