Self Help - Operation
Before calling for service, check the following:
Table 9: Self Help - Operation
Oven ProbNem ProbNem SoMng Steps
F03 or F04 Error appear in the A problem with the lock occured. Turn power off and turn it back on again
display window, after a few seconds. The oven should run a latch auto-test. If condition
persists, note the code number and call an authorized sewicer,
Other F Error appears in the Turn power off and turn it back on again after a few seconds. If condition
display window, persists, note the code number and call an authorized sewicer,
Cooling fan continues to run This is normal. The fan turns off automatically when the electronic
after oven is turned off components have cooled sufficiently.
Oven door is locked and will not Turn the oven off at the circuit breaker and wait a few seconds. Turn breaker
release, even after cooling back on. The oven should reset itself and will be operable.
Oven is not heating Hake sure the oven temperature has been selected.C beck the circuit
breaker or fuse box to your house. Hake sure there is proper electrical
power to the oven.
Oven is not cooking evenly Check oven calibration. Adjust calibration if necessary (see Oven Offset,
Page !7). Refer to cooking charts for recommended rack position. Always
reduce recipe temperature by 25°F when baking with convention bake
mode.
Oven temperature is too hot or The oven thermostat needs adjustment. See Calibrating Oven Temperature,
too cold Page !7.
Oven light is not working Replace or reinsert the light bulb if loose or defective. See Page 15. Touching
properly the bulb with fingers may cause the bulb to burn out.
Oven light stays on Oven light comes on automatically when oven begins heating.Press LIGHT to
turn oven light off. If oven is off, check for obstruction in oven door or check
to see if hinge is bent.
Cannot remove lens cover on There may be soil build-up around the lens cover. Wipe lens cover area with
light a clean dry towel prior to attempting to remove the lens cover,
Oven will not self=clean properly Allow the oven to cool before running self=dean. Always wipe out loose soil
or heavy spill-over before running self<lean. If oven is badly soiled, set
oven for a four=hour Self=Clean. See Self=Cleaning, Page 13.
Clock and timer are not Hake sure there is proper electrical power to the oven. See the Clock and
working properly Timer sections on Pages 2 and 8.
Excessive moisture When using bake mode, preheat the oven first. Convection bake will
eliminate any moisture in oven (this is one of the advantages of convection).
Porcelain chips When oven racks are removed and replaced, always tilt racks upward and do
not force them to avoid chipping the porcelain.
HOW TO OBTAIN SERVICE
For authorized service or parts information call 8OO/944o2904,
We want you to remain a satisfied customer, If a problem occurs that is not resolved to your satisfaction,
write to Bosch Customer Support, 5551 HcFadden Avenue, Huntington Beach CA, 92649 OFphone 800-944-
2904.
Please include the Hodel Number, Serial Number and date of original purchase and installation.
English • 19
To Next Page
Loading...
