recording or for scheduled local recording to improve
the overall recording reliability. Recording
management can be controlled by the Bosch Video
Recording Manager (VRM), or the camera can use
iSCSI targets directly without any recording software.
Advanced networking capabilities
The AUTODOME offers advanced capabilities so you
can configure the camera to take advantage of the
latest networking technology.
The AUTODOME offers Quality of Service (QoS)
configuration options to ensure fast network response
to PTZ data and images. Quality of Service (QoS) is
the set of techniques to manage network resources.
QoS manages the delay, delay variation (jitter),
bandwidth, and packet loss parameters to guarantee
the ability of a network to deliver predictable results.
QoS identifies the type of data in a data packet and
divides the packets into traffic classes that can be
prioritized for forwarding.
The AUTODOME also supports the IPv6 internet-layer
protocol for packet-switched internetworking across
multiple IP networks. IPv6 uses 128-bit addresses
(IPv4 uses 32-bit addressing), which allows for many
more devices and users on the internet as well as
extra flexibility in allocating addresses and efficiency
for routing traffic.
Dual power options
All models can be powered by a High Power-over-
Ethernet (Bosch High PoE)-compliant network using a
Bosch High PoE Midspan (sold separately) over a
single network cable and/or a 24VAC power supply.
Certain models can also be powered by any PoE+
Power Sourcing Equipment (PSE; midspan or switch)
that is compliant to the IEEE 802.3at, class 4 standard
and/or a 24 VAC power supply.
When powered using High PoE or PoE+ (IEEE 802.3at
class 4) configuration, only a single cable connection
is required to power and to control the camera while
also viewing images from the camera. For additional
system reliability, users also have the option to
connect the 24 VAC power supply to the camera while
using High PoE.
Only in-ceiling models and indoor/outdoor pendant
models used in indoor applications (without heaters
on) can use High PoE or PoE+ (including non-Bosch
PoE+ PSE).
Ease of installation and servicing
The camera has been designed for quick and easy
installation; a key feature from Bosch CCTV products.
All housings feature recessed screws and latches for
increased tamper resistance.
Indoor/outdoor pendant housings are rated to provide
IP66 protection and offer an operating temperature
range down to -40 °C (-40 °F). The indoor/outdoor
pendant comes fully assembled with a sunshield and
ready for wall or pipe applications with the proper
mounting hardware (sold separately). In addition, the
camera models with both pendant and in-ceiling
housing come equipped with a low-impact, high-
resolution acrylic bubble for enhanced image clarity.
You can easily convert the outdoor pendant for indoor
applications by removing the sunshield.
Bosch offers a full complement of hardware and
accessories (sold separately) for wall, corner, mast,
roof, pipe mount, and in-ceiling applications for indoor
and outdoor environments, which allow the camera to
be adapted easily to individual site requirements.
Video management system support
The camera ships with Bosch Video Client (BVC), an
easy-to-use software from Bosch that is suitable for
midsize installations. For large enterprise systems,
AUTODOME cameras can be used with Bosch Video
Management System (BVMS), which allows enhanced
video management and viewing capabilities.
In addition, the camera is supported/integrated into all
of the leading third party video management systems.
ONVIF conformant
The AUTODOME Series conforms to the ONVIF Profile
S specification allowing easy integration with the
conformant devices and VMS.
For more information about ONVIF, visit
www.onvif.org.
The camera conforms to the ONVIF (Open Network
Video Interface Forum) specification which guarantees
interoperability between network video products
regardless of manufacturer. ONVIF conformant devices
are able to exchange live video, audio, metadata and
control information. They are automatically discovered
and connected to network applications such as video
management systems.
Fiber Optic Kit
Bosch offers the optional VG4-SFPSCKT, a unique
media converter module for use with AUTODOME
cameras. This media converter module is designed to
accept a wide-range of 10/100 Mbps SFP modules for
use with Multimode or Singlemode optical fiber with
LC or SC connectors.
The media converter module along with the SFP
module is user-installed directly into the camera‘s
power supply box to provide an integrated fiber optic
solution.
Unsurpassed reliability
As with all Bosch products, the camera has been
subjected to the industry’s most comprehensive and
demanding battery of endurance tests such as HALT
(highly accelerated life testing) to make sure it will
hold up through years of use. And of course, it comes
with Bosch’s industry-leading 3-year warranty.
Access security
Various security levels are available for accessing the
network, the camera, and the data channels. As well
as password protection with three levels, 802.1x
authentication using a RADIUS (Remote Authentication
Dial In User Service) server is supported. To secure
Web browser access, use HTTPS with a SSL certificate
3
| AUTODOME 7000 HD
To Next Page
Loading...
