Master keypad arming
With a master keypad, either all areas or a single area can be
armed in AWAY mode.
Arming all areas
4 Enter your code, press [0] [0] and [*].
P The system beeps twice, the STAY indicator flashes slowly
and exit time starts. After the exit time, the STAY indicator
is lit and all areas are displayed as armed.
Arming all areas (quick arm)
4 Press and hold [*] until the system beeps twice.
P The system beeps twice, the STAY indicator flashes slowly
and exit time starts. After the exit time, the STAY indicator
is lit and all areas are displayed as armed.
Arming a single area (direct AWAY arm)
Arming a single area with a master keypad is only possible for
users with the permission level master 1 or master 2.
4 Enter your code, press the 2-digit area number of the area
to be armed and press [*].
P The STAY indicator flashes slowly and exit time starts. After
the exit time, the STAY indicator is lit and the selected area
is displayed as armed.
4 Repeat if you want to arm multiple areas.
To enable/disable this function contact your installer.
Key switch arming
Users can use a key switch to arm an area.
4 Activate the key switch.
P The STAY indicator flashes slowly and exit time starts. After
exit time, the STAY indicator is lit.
To enable/disable this function contact your installer.
RADION RF keyfob arming
Users can use a RADION RF four button keyfob to arm an area
via the third button.
4 Press the third button of the RADION RF four button
keyfob.
22
en | Arming and disarming areas AMAX panel
2017.04 | 07 | F.01U.295.569 Bosch Sicherheitssysteme GmbH
To Next Page
Loading...
