Bosch AMAX panel 2000 - Bypassing; Bypassing Zones; Bypassing Faults and Tamper Conditions

AMAX panel 2000 / AMAX panel 2000 EN Bypassing | en 15
Robert Bosch Engineering and Business Solutions Limited User Guide F.01U.249.500 | V2 | 2011.11
7Bypassing
7.1 Bypassing Zones
By bypassing Zones, one or more zones are disabled for one arming cycle. After bypassing a
zone, you can arm the system even when a zone is in alarm state.
How to bypass a zone
1. Enter your code and press [9] [#]. The STAY indicator flashes fast.
2. Enter the zone number you wish to bypass, then press the [*] key.
(If you wish to bypass multiple zones, please repeat step 2).
3. If you wish to cancel bypassed zone, enter the zone number of the bypassed zone , then
press the [*] key.
(If you wish to cancel several bypassed zones, please repeat step 3.)
4. Press [#] to exit.
7.2 Bypassing Faults and Tamper conditions (Except Zone
Tampers)
Bypassing Faults and Tamper conditions, one or more faults and tamper conditions are
disabled for one arming cycle. After bypassing a Fault or Tamper condition, you can arm the
system even when a Fault or Tamper condition exists.
How to bypass faults and tamper conditions
1. Enter user code + [97] and press [#].
Two beeps sound.
NOTICE!
If the selected zone is already bypassed, when operating this zone, the bypass from this zone
will be cancelled.