Bosch APC-AMC2-4W - Resetting the Network Configurations

AMC2 4W Operating | en 51
Bosch Security Systems Installation manual F.01U.024.965 | V.4 | 2006.09
Fig. 6.2 Restarting the AMC2 4W with the provided screw driver
6.3.2 Resetting the Network Configurations
1. Reset the AMC2 4W as described above (in download pro-
gram).
2. Open the upper case of the AMC2 4W as described in
Section 5.3 Opening the AMC2 4W Case.
3. Set all six DIL switches of the RS-485 selector to ON
4. Press the tamper switch on the upper left side of the board
The AMC2 4W will now have the following network configura-
tion:
• DHCP = 0
• IP = 127.0.0.1