22
12. Installing and aligning the appliance
Align the appliance with the furniture fronts.
Place marking-out level over the installation aid parts on
the door.
The installation aid parts on the door have been designed for
the following total thickness of furniture doors:
–
3
/
4
" (19 mm)
–1
1
/
2
" (38 mm)
Always take account of the possible differing thickness of the
furniture fronts which are to be fitted subsequently.
The height-adjustable feet at the front and rear can all be
adjusted from the front.
Front:with open-ended wrench
1
/
2
" (SW13)
Rear:with
5
/
16
" (8 mm) hex nut driver via flexible shaft.
A mark is attached to the appliance base and is used as
a standard gage for height adjustment. When adjusting the
height, align this mark at a height of 1
1
/
2
" (32 mm) above
the floor.
Unscrew the height-adjustable feet until the mark on
the base has reached the indicated guide dimension
(1
1
/
4
" / 32 mm).
Align the furniture fronts with the spirit level.
m
CAUTION
m
Never use a cordless screwdriver!
Risk of damage to the appliance.
NOTE
– Do not twist or jam the appliance inside the cavity!
When unscrewing the height-adjustable feet,
proceed gradually: Always alternate between left
and right, left and right, etc..
– The adjustment of the rear feet is facilitated if the
appliance is unloaded at the rear.
– If using a wooden beam as an alternative anti-tip
device according to point 6 of this installation
manual, rotate the appliance all the way towards the
wooden beam.
NOTE
It is very important to comply with this dimension for
the subsequent alignment of the furniture fronts.
To Next Page
Loading...
Need help?
General
