30
Using the positioning aid, set both longitudinal sides of
the furniture door parallel.
Using a square, extend the drill hole marks which you
have just made to the vertical marks.
Mark and drill the holes.
Screw on the fixing plates (10x).
23. Attaching the adjusting rail to
the furniture door
(freezer compartment)
Measure the distance X between the adjusting rail and
the overhead furniture/fixtures.
Loosen the 2 nuts and remove the adjusting rail.
Mark this amount X on the rear of the furniture door.
Determine and mark the centerline of the furniture door.
Put on the adjusting rail and align along the marks.
Mark the drill holes.
Drill the holes.
Screw on the adjusting rail tightly.
To Next Page
Loading...
