26
17. Attaching the toe kick panel
If required, cut the toe kick panel to the required length.
Attach the base panel to the appliance.
Remove the protective film from the adhesive pads on
the Velcro.
Fit the toe kick panel to the base panel and press firmly
into place.
Put on the base panel (do not screw on) and measure
the difference in depth Y between the base panel and
toe kick panel of the adjacent furniture.
Remove the base panel.
Loosen the brackets for attaching the base panel and
push in all the way.
Pull out the brackets by the measured amount Y.
Screw the brackets tightly
m
CAUTION
m
The maximum height of the toe kick panel is 4" from
the top of the floor.
Do not cover ventilation slots in the base panel.
Risk of damage to the appliance.
To Next Page
Loading...
