33
Adjust the furniture door using the threaded rod
(Torx screwdriver). Re-examine the dimensions
of the crack continuously.
Close the door and check that the depth of the furniture
front is aligned with the adjacent fronts.
If required, correct.
Tighten the bracket screws to fix the depth alignment.
Close the door and check the side alignment. Correct
by gently tapping the edge of the open furniture door
with your hand.
Tighten the nuts on the adjusting rail. This will fix the side
alignment of the door.
26. Attaching the furniture door
(freezer compartment)
Remove fixing bracket from one side of the drawer.
To do this, loosen the fastening screws only.
Loosen fixing bracket on the other side of the drawer
and pull slightly off the appliance door.
To do this, loosen the fastening screws only.
Open drawer.
Hang the furniture door with adjusting rail over the
double threaded bolts.
Raise furniture door slightly and push the fixing plates
down over the fixing brackets on the drawer.
Insert removed fixing brackets into the fixing plates and
push over the fastening screws.
Screw the nuts a little onto the double threaded bolts.
Do not tighten!
NOTE
Now fit the furniture handles which are screwed from
behind!
To Next Page
Loading...
Need help?
General
