Install a communication program (if required) (Refer to Install a communication program,
page 24)
Configure the communication module (non SDI2 control panels)
Verify LED activity
Review signal strength on the cellular communicator. Refer to your cellular communicator
Installation Guide for more information on signal strength.
Installation is complete
See also
– Configuration, page 17
– Maintenance and troubleshooting, page 39
6 en | Introduction
Conettix Plug-in Communicator
Interface
2013.09 | 02 | F.01U.282.875 Installation and Operation Guide Bosch Security Systems, Inc.
To Next Page
Loading...
