58300000181895 ARA EN A JUNE 2014 Service Manual for Bosch Benchmark Series Built-in Wall Ovens
Page 28 of 45
Copyright by BSH Home Appliances Corporation 1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614 800 944-2904
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
Figure 41 Insert the prongs on the new halogen bulb into the holes in the socket
Figure 42 Removing the light receptacle
Figure 43 Lamp receptacle assembly
5. Support the lens and repeat step 4 with the second clip; carefully
slide the lens out and set aside; do not force the lens out – it
should detach easily.
6. Pull the halogen bulb from its socket; if it is difficult to grasp the
bulb using one hand, use both forefingers to pinch behind the
rounded part of the bulb, then pull the bulb out using both hands.
7. Grasp the new bulb with a clean, dry cloth. Align the bulb prongs
with the socket holes and press into place.
8. Reinstall the glass lens cover by inserting it into the mounting clips
and gently pressing the end of each clip until it snaps in place and
secures the lens.
9. Restore power to the oven and test operation.
6.6.2 Replacing the Lamp Receptacle Assembly
The lamp receptacle assembly service part includes the receptacle,
glass lens and halogen bulb.
1. Turn off power to the oven at the main power supply (fuse box or
breaker box).
2. Remove oven racks to provide access to the light lens and
halogen bulb.
3. Optional: on ovens with bottom-hinge doors, the door may be
removed to provide easier access and visibility.
4. Remove the screw securing the receptacle to the cavity side wall.
5. Carefully pull the receptacle away from the cavity wall, until the
wire plug can be disconnected from the main harness; be careful
not to drop the main harness wires.
6. Install the new lamp receptacle.
7. Restore power and test operation.
NOTICE
Any surface contamination from the oil of fingers or hands can cause
damage to halogen bulbs and premature failure. Direct contact with
the bulb should be avoided. Always hold a halogen bulb with a dry
cloth or clean paper towel.
To Next Page
Loading...
