Bosch Benchmark HBLP651LUC - Service Mode; Accessing Service Mode; Setting the Option Code

58300000181895 ARA EN A JUNE 2014 Service Manual for Bosch Benchmark Series Built-in Wall Ovens
Page 39 of 45
Copyright by BSH Home Appliances Corporation 1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614 800 944-2904
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
7.2 Service Mode
Service mode provides access to Option Code settings, error
memory, relay tests, front panel tests, program version information
and EEPROM version information. It can be accessed at any time,
including while an error is displayed. If accessed while a mode is
running, the mode will be cancelled.
7.2.1 Accessing Service Mode
1. Press and hold Enter, numeric 1 and Bake for 5 seconds, or until
Service Mode appears in the display.
2. Press Next (soft key) to navigate through the menu. Additional
instructions will appear in the display.
3. Press Oven Clear/Off on single ovens or Upper Clear/Off on double
ovens to exit Service Mode any time (except while in the Front
Panel Test).
Table 8 reflects the Service mode menu options available.
Software revision
Current version number for the UI software
and EEPROM version
Option code
Displays current option code; press Edit (soft
key) to enter a new code. Press
Enter (soft
key) or
Enter button to save.
Error Memory
If errors have been logged, press
Error
Memory
(soft key) to navigate through the
error menu. Press
Back (soft key) then Next
(soft key) to continue to Relay Tests.
Relay Tests
Relay and DLB are turned on when soft key 3
is pressed. Soft key 2 turns off the previous
relay/DLB and advances to the next relay
test option. Pressing
Back (soft key) will
return to the main menu.
1 Cavity 1 Door Lock
2 Cavity 2 Door Lock
3 Cooling Fan
4 Illumination
5 Cavity 1 Conv Fan
6 Cavity 2 Conv Fan
7 Cavity 1 Bake
8 Cavity 1 Broil
9 Cavity 1 Ring
10 Cavity 2 Bake
11 Cavity 2 Broil
12 Cavity 2 Ring
Front Panel Test
Used to ensure the TCM is connected
and operating properly. The front
panel test is based on the Option
Code that was saved at the time
Service Mode was initiated. If the
code was changed, exit Service Mode
then start again. Press
Start Panel
Test
(soft key) to activate this test.
After all expected buttons have been
pressed, the display returns to the
main menu. Press
Next (soft key) to
return to the first Service Mode menu
option. To exit the test, it must
either be successfully completed
or the power must be reset.
7.2.2 Setting the Option Code
Option codes are programmed into the control module and are used
to define cavity type and oven configuration. In the event it becomes
necessary to manually program an option code in Service mode, the
table below can be used as a reference.
Model(s) Option Code Model Option Code
HBLP451LUC
HBLP451RUC
HBLP451UC
HBLP751UCC
HSLP751UCC
3058
HBLP651LUC
HBLP651RUC
HBLP651UCC
3358
Table 9 Option codes for Benchmark series wall ovens
Table 8 Service mode menu options for Benchmark series wall ovens