58300000181895 ARA EN A JUNE 2014 Service Manual for Bosch Benchmark Series Built-in Wall Ovens
Page 34 of 45
Copyright by BSH Home Appliances Corporation 1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614 800 944-2904
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
Figure 51 Removing the RH hinge receiver
Figure 50 Double oven corner bracket
5. On double ovens, remove the corner brackets between the upper
and lower oven.
6. Remove the side panel(s).
7. From the front of the oven, remove the two screws securing the
hinge receiver to the oven.
8. Pull back the side insulation to reveal the hinge receiver and
remove the part.
9. Install the new hinge receiver.
10. Reinstall the oven door and test door operation.
11. Reinstall the side housing cover.
12. Restore power to the unit and test operation.
13. Slide the oven back into the cutout and reinstall the side trim
pieces.
To Next Page
Loading...
