119
Online calibration of measurement channels
Performing the offset calibration:
Apply the desired physical condition to the sensor
(e.g. 1G to an acceleration sensor)
Open the channel’s online page by double clicking on the channel name
Enter the physical target value (e.g. 1G) and press the ‘Calibrate’
button
C 60 Online Measurement
Internal | BEG/EMS1 CsM
| 6/4/2010 | ©
Bosch Engineering GmbH 2009. All rights reserved, also regarding any disposal, exploitation,
reproduction, editing, distribution, as well as in the event of applications for industrial property rights.
Motorsport
C 60 Online Measurement + Calibration
Calibration
target value
Initiate
calibration
To Next Page
Loading...
