159
Software Setup
Configure the burst IP address of the C 60
(This address must be compatible with the address range of the pit PC, the BT-60 and the BR-60)
Open a measurement sheet
Drag the ‘BURST_DEVICE_IP’
to the measurement sheet
Switch to ‘Race Mode’
Configure the desired IP address
C 60 Recording and Telemetry
Internal | BEG/EMS1 CsM
| 6/4/2010 | ©
Bosch Engineering GmbH 2009. All rights reserved, also regarding any disposal, exploitation,
reproduction, editing, distribution, as well as in the event of applications for industrial property rights.
Motorsport
Configuration of Burst Telemetry
Drag+drop
To Next Page
Loading...
