Bosch CDL2-15G - Detector Installation Procedures

12 en | Installation
Commercial Series TriTech and TriTech AM
detectors
2022.01 | 01 | F.01U.401.708
Installation manual
Bosch Security Systems B.V.
5 Installation
This section includes hardware details and the instructions you need to install the motion
detector base.
5.1 Self-locking cam
The detector includes a self-locking cam for easy installation. Refer to the following
information to open and close the detector.
Open the detector and remove the base
1. Insert a flathead screwdriver into the locking tab hole.
2. Turn to the unlock position.
3. Slide, then lift the detector from the base.
Attach the detector onto the base
i
Notice!
When you remove the detector from the base, the cam automatically returns to the locked
position. When you place the detector onto the base, the cam must remain in locked position.
Do not manually change the cam once you remove the detector from the base; doing so
unlocks the detector and prevents you from putting the detector correctly onto to base.
1. Put detector onto the base.
2. Slide the detector up until you hear it "click."