Bosch Climate 8100i - User Manual

56 pages

Save Page as PDF

To Next Page

6721821568 (2020/11) div

en Air/air heat pump Operation manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2

da Luft-/luft-varmepumpe Betjeningsvejledning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12

fi Ilma-ilmalämpöpumppu Käyttöohje . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22

no Luft/luft-varmepumpe Bruksanvisning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32

sv Luft-/luftvärmepump Bruksanvisning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 42

Climate 6100i/8100i

0010031002-001

CL6100i-Set 50 HE, CL6100i-Set 65 HE, CL8100i-Set 65 HE

Main Page

Other manuals for Bosch Climate 8100i

Installation Manual44 pages

Questions and Answers

C
Crystal WilliamsAug 7, 2025
Why does my Bosch Heat Pump outdoor unit start and stop continuously?
- J
  Jocelyn CastroAug 7, 2025
  If your Bosch Heat Pump's outdoor or indoor unit starts and stops continuously, there might be insufficient or too much refrigerant in the system. Check the tightness of the pipes, reseal if needed, and refill the refrigerant or remove refrigerant with a refrigerant recovery unit. Also, moisture or impurities in the refrigerant circuit could be the cause, so evacuate the refrigerant circuit and fill it with new refrigerant. High voltage fluctuations can also cause this issue, so install a voltage regulator. Finally, a defective compressor could be the problem, requiring a compressor replacement.
P
Penny EscobarAug 22, 2025
How to fix low output on my Bosch Heat Pump indoor unit?
- M
  mruizAug 22, 2025
  If your Bosch Heat Pump's output is too low, the heat exchanger of either the outdoor or indoor unit might be soiled. Clean the heat exchanger. Also, check for a lack of refrigerant. Inspect the pipes for tightness, reseal if necessary, and refill the refrigerant.