Operation
7
Compress 7001i/7400i AW AWE – 6721835320 (2021/09)
The standard display refers only to the displayed heating circuit.
Changing the required room temperature in the standard display only
affects the heating circuit displayed.
Table 2 Symbols in the display
An overview of the structure of the main menu and the position of the
individual menu items can be found at the end of this document.
An overview of the items that can be found in the info menu is also found
at the end of this document.The info menu is useful to get instant
information of the status of the heat pump.
Each of the following descriptions takes the standard display as its
starting point ( Fig. 5).
3.2.2 Switching off
The user interface is powered via the BUS interface and is normally
switched on. The system should only be shutdown temporarily,
for example when cleaning filters. The complete system is deactivated
and there is no frost protection during a shutdown.
▶ To temporarily switch off the system:
– Press and hold the selector until a pop-up menu is displayed.
– Select Yes in the menu Switch to standby mode?
Item Symbol Explanation
1 Value display (current temperature):
• Room temperature if a remote control is
installed for the actual heating circuit.
• Heat source temperature if there are no
remote control installed.
2 – Info line: display of time of day, day of the
week and date.
3 Additional temperature display: outside
temperature, temperature of the solar
collector or a DHW system.
For ventilation: display of the ventilation level.
For ventilation: frost protection (reduced
ventilation).
4 – Text information: e.g. the designation of the
temperature currently displayed ( Fig. 5,
[1]). If a fault is present, corresponding
information will be displayed here until the
fault has been rectified.
5 The key block is active (hold down the DHW
key and selector to activate or deactivate the
key block).
6 Solar circulation pump is in operation.
DHW heating is active
DHW thermal disinfection active
Extra DHW active
Pool heating active
Heating active
Cooling active
Energy supplier interruption
External input active (remote)
Holiday mode active
Time program active
Smart grid function active
Screed drying active
Electric booster heater active
Power guard active
Additional heat source active
Defrost function active
Compressor (Heat pump) active
An IP-module is installed and communication
to the server is active.
7 Op. mode Operating mode: [Optimised operation] no
time program active.
Operating mode: [Program 1] | [Program 2]
automatic mode active (according to time
program) for displayed heating circuit.
Operating mode: heating mode active.
Operating mode: setback mode active.
Item Symbol Explanation
To Next Page
Loading...
