CC8313 control unit
13
Condens 7000 F – 6720871579 (2022/10)
5.6.2 Selection of control units
Other control units on the CBC bus can only be accessed from the master
control unit.
If several control units are linked, the control unit for the system to be
operated must be selected first. The other levels (e.g. heating circuits)
can then be displayed and selected.
All functions of another control unit logged on to the CBC bus (Slave) can
be viewed and adjusted from the master control unit. The functions can
be accessed from the master control unit and at the local control unit
simultaneously.
If the same parameters are changed from the master control unit and at
the local control unit, the last values entered apply.
5.6.3 Networked control units
To call up the functions, displays and messages for a control unit, the
control unit whose settings and messages are to be displayed must
always be selected first.
To select a control unit:
▶Tap on System ( Figure 10, [3], page 12).
The system overview with connected functions and control control
unit (slave control units (Subsystem)) opens.
Fig. 11 System overview (example)
[1] System of the master control unit
[2] Status display of the respective control unit
[3] Selected control unit (here, master control unit with control unit
address 00)
[4] Networked control unit (slave control unit with address 01)
[5] Changes to the view of the master control unit (only displayed
with slave control units)
[6] Connected HSM plus modules
[7] Networked components (slave control unit with address 02)
[8] Further information on the selected control unit
[9] Press symbol to return to the previous level/screen of the selected
control unit
[10] Press symbol to access the selected control unit in the system
overview or in the control unit overview
▶ Tap on the desired control unit.
The system overview of the selected control unit opens.
Fig. 12 System overview (example)
[1] Heat production (heat generator connected to the selected
control unit)
[2] Display of selected control unit (with display of the address
01 ... 15)
[3] System (Heat distribution of the selected control unit)
[4] Display of the control unit address in the networking icon.
Changes to the view of the master control unit (only displayed
with slave control units)
0010033482-002
12:00
1 43
7 58910
2 2
02
6
0010034393-001
12:00
1 32
4
02
To Next Page
Loading...
