Product Information
5
Condens 7000 F – 6720871579 (2022/10)
2.4 Product data for energy consumption
The following product data satisfy the requirements of the EU Regulations No. 811/2013, No. 812/2013, No. 813/2013 and No. 814/2013
supplementing Directive 2010/30/EU.
Table 2 Product data for energy consumption
2.5 Water quality (fill and top-up water)
▶ For information regarding the water quality, see the enclosed
operator's log "Water quality requirements for heat sources made
from aluminium".
Do not use softened water as fill and top-up water.
2.6 Product overview
The Condens 7000 F is a floor standing condensing boiler with an
aluminium heat exchanger.
2.6.1 Product Description
The main Condens 7000 F components are:
• Control unit
• Boiler block
• Appliance frame and casing
•Gas burner
The control unit monitors and controls all electrical boiler components.
The boiler block transfers the heat generated by the burner to the
heating water. The thermal insulation reduces the radiation and standby
losses.
The control unit enables the standard operation of the heating system.
For this, it makes the following functions available, including:
• Switching the heating system on/off
• Setting the DHW temperature and the maximum boiler temperature
in heating mode
• Status display
This floor standing boiler can be operating via the CC 8313 or MX25
control unit.
Many additional functions that enhance control and operating
convenience as well as information on the heating system settings are
described in the corresponding Technical documentation of the installed
control unit.
Right-hand version 8732909990 8732909991 8732909992 8732909993 8732909994 8732909995
Left-hand version 8732909996 8732909997 8732909998 8732909999 8732910000 8732910001
Product data Symbol Unit
Product type – – Condens
7000 F-75
Condens
7000 F-100
Condens
7000 F-150
Condens
7000 F-200
Condens
7000 F-250
Condens
7000 F-300
Floor standing condensing
boiler
– – Yes Yes Yes Yes Yes Yes
Nominal heat output P
rated
kW 69 93 140 186 233 280
Available heat output
At rated output and high-
temperature operation
1)
1) High temperature operation means a return temperature of 60 °C at the boiler inlet, and a flow temperature of 80 °C at the boiler outlet.
P
4
kW 69.4 93.0 139.8 186.2 233.1 280.0
At 30 % of rated output and
low-temperature operation
2)
2) Low temperature operation means a return temperature (at the boiler inlet) of 30 °C for floor standing condensing boilers, of 37 °C for floor standing boilers, and 50 °C for
other boilers
P
1
kW 23.1 31.0 46.5 62.1 77.7 93.0
Useful efficiency
At rated output and high-
temperature operation
1)
4
% 88.3 88.1 88.1 88.3 88.2 88.3
At 30 % of rated output and
low-temperature operation
2)
1
% 97.8 98.0 97.7 98.1 98.0 97.7
Auxiliary power consumption
At full load el
max
kW 0.083 0.156 0.250 0.234 0.298 0.336
At part load el
min
kW 0.028 0.032 0.046 0.048 0.049 0.057
In standby mode P
SB
kW 0.009 0.009 0.009 0.009 0.009 0.009
Other data
Standby heat loss P
stby
kW 0.161 0.161 0.183 0.247 0.261 0.298
Energy consumption of the
ignition flame
P
ign
kW – – – – – –
NOx emissions NOx mg/kWh 41 49 34 36 32 36
To Next Page
Loading...
Need help?
General