Product description of optional control units
7
Condens 7000 F – 6720871579 (2022/10)
Fig. 2 Condens 7000 F, 150...300 kW main components (shown: right-hand version; cleaning cover and flow and return are located on the right)
[1] Boiler front panel (2-part)
[2] Gas valve
[3] Gas burner with burner rod
[4] Control unit CC 8313 (optional)
[5] MX25 control unit (optional)
[6] Boiler block with thermal insulation
[7] Boiler casing
[8] Condensation catch pan and siphon
[9] Bottom panel
[10] Burner control unit
The right-hand versions of the boiler are shown. In this case the cleaning
cover and the flow and return are located on the right.
In the left-hand version, the cleaning cover and flow and return are
located on the left.
2.6.2 The heating system is operated and monitored via App or
Web Portal
We offer, in combination with the relevant control unit, a comprehensive
range of products for monitoring, diagnosis and control of the floor
standing boiler via mobile terminal devices, PC or tablet.
3 Product description of optional control units
3.1 Product description of optional control units
The Condens 7000 F is equipped with a control unit that was assigned
when ordering.
A brief description of the optional control units follows. Additional
functions that enhance control and operating convenience as well as
information on the heating system settings are described in the
corresponding Technical documentation of the installed control unit.
3.2 Switching on the boiler at the control unit
▶ To commission the control unit, observe the technical
documentation for the specific control unit.
To avoid frequent cycling of the burner and to ensure efficient operation,
the heating curve should generally be set as low as possible.
0010014184-001
9
6
7
4
5
3
2
1
810
To Next Page
Loading...
