Need help?Do you have a question about the Bosch ConnectS2 and is the answer not in the manual?
Details of the Connect S2 Bundle E set, including components and order number.
Information about the standalone Connect S2 device for use with Solar Frame or as replacement.
Components and setup for the Solar Frame set, enabling a solar-powered tracking device.
Mounting accessories for fixing the Solar Frame on carriers up to 3mm thickness.
Mounting accessories for fixing the Solar Frame on carriers from 4mm to 13mm thickness.
Adhesive kit required for mounting sets, including static mixer and adhesive cartridge.
Tool for applying adhesive from cartridges, reusable.
AC power supply for use in USA and Canada with 110V mains voltage.
Replacement AC power supply for use in Europe with 230V mains voltage.
Adapter for connecting the power supply to the M8 connector of the Connect S Gateway.
Set of spare parts including washers, flange nuts, and plugs for Solar Frame mounting.
Describes the sensor scanning process, filtering, and data acquisition capabilities.
Details on configuring sensor scan and data upload intervals and their combinations.
Function to extend sensor and upload intervals when battery charge level is low.
Steps to activate the Connect Gateway using an NFC scanning device and Bosch server.
Process for linking the Connect Gateway to your asset using mobile apps and QR code.
Crucial safety warnings and precautions for installing the device to prevent harm.
Basic guidelines and recommendations for performing the device installation.
Instructions for attaching the gateway to a metal surface using neodymium magnets.
Guide for securely mounting the gateway using two M8 screws and spring washers.
Specific instructions and cautions for mounting the Solar Frame accessory.
Step-by-step guide for applying AT-8040 adhesive for secure mounting.
Instructions for gluing the Solar Frame directly onto smooth, flat surfaces.
Method for gluing the Solar Frame on the backside of a carrier plate (1-13mm thickness).
Procedure for securely screwing the Solar Frame using 5mm screws and flange nuts.
Information on device status indicated by LED signals and battery status.
Recommendations for maintaining the Connect Gateway, including solar cell cleaning.
Detailed technical specifications including dimensions, weight, power, and battery life.
Technical specifications for the AC power supply unit, including variants and operating conditions.
Technical specifications for the Solar Frame, including dimensions, weight, and power output.
Details on the battery type, energy content, weight, and transport test requirements.
Safety precautions for handling and transporting magnets, including postage and airfreight.
Transport regulations and classifications for shipping the device via road, rail, and sea.
Guidelines and regulations for transporting the Connect S2 Gateways by air.
Proper disposal methods and recycling instructions for the device under WEEE directive.
Declaration of compliance with EU directives for the Connect S2 and Solar Frame.
Information on export restrictions and operating the device in countries outside the EU.
FCC notices, authorization, and statements regarding radio frequency exposure.
Precautions for handling the device's lithium battery to prevent fire hazards.
Warnings and guidelines for safe device installation to prevent injury or damage.
Safety advice and restrictions for mounting the device using magnetic attachments.
Detailed safety measures for handling strong magnets to avoid contusions, damage, or interference.
Information regarding potential allergic reactions to nickel in magnet coatings.
Safety considerations and specific cautions when mounting the Solar Frame accessory.
License terms and conditions for the ARM CMSIS and system files component.
License terms for the STMicroelectronics STM32 HAL Drivers software component.
License terms for the Segger RTT software component used for communication.
License terms for the RFC2822 standard component.
To Next Page
General
