Bosch CR 10 - Function as Zone Controller; Function as Remote Control; Operation; Display and Control Elements

Operation | 5
6720830560 (2015/06)
CR10
2.2 Function as zone controller (only 2-wire BUS/EMS 2)
The CR 10 can be used in conjunction with zone modules without a higher-level user
interface as a controller for max. 8 heating circuits (for further information, see the
technical documentation of the zone module).
The zone temperature is controlled in the same way as with the function of a room
temperature-dependent controller with set flow temperature control.
2.3 Function as remote control (only 2-wire BUS/EMS 2)
The CR 10 can be used as a remote control for a higher-level user interface.
The time program is determined by the higher-level user interface. The required room
temperature can be temporarily changed at the CR 10 until the next switching time of
the time program. After this, the higher-level user interface has priority until the
setting is changed again at the CR 10.
3 Operation
[1] Display
[2] Selector: select (turn) and confirm (press)
6 720 646 193-09.1O
°C
°F
1
2