Bosch CR 10 - Operation (Example); Opening the Service Menu

Information for heating contractor | 9
6720830560 (2015/06)
CR10
A reset restores the default setting. In the event of a power failure, the settings
including the heating circuit allocation are retained.
4.6 Operation (example)
S.1 nF.12.01 Software version
3)
F.1 1 | 0 Reset CR 10
0: Do not reset
1: Reset
1) Values in bold = default setting
2) Only one CR 10 can be allocated to each heating circuit.
3) Turn the selector to read out the whole value.
Opening the service menu Result
▶ Press and hold the selector until 2 dashes are displayed.
▶ Release the selector to display the first setting.
Changing the setting (e.g. heating circuit HC) Result
▶ Select the setting.
▶ Press the selector to display the current value.
▶ Press the selector again to change the value.
▶ Select and confirm the required value.
▶ Press and hold the selector until the setting is displayed again.
Setting Adjustment range
1)
Description
°C
°F
°C
°F
°C
°F
°C
°F
°C
°F
°C
°F
°C
°F